NERO LARP :: Forums :: Main Category :: General Discussion
 
<< Previous thread | Next thread >>
weapon core question:URGENT:
Moderators: Administrator, KatieMueller, AdamTaylor, jvalenti, Clint, NickDenny, ShellyHollon, KnightofEvendarr, jasonmote, JSchneider, fdhogan, DDS, jvalentinero, BrianCook, dcashel
Author Post
PapaGrelada
Wed Jul 22 2015, 06:20PM
Registered Member #58781
Joined: Wed May 13 2015, 06:52PM
Posts: 2
I have a pole-arm but the pvc pip I used was too whipy. Regrettably no one in the near area sells aluminum pipes for coring. Is it possible to use a EMT electrical conduit pipe for the core? if not what is another durable, inflexible pipe core substitute that is plentiful( you don't have to look hard and travel 30 miles), durable and relatively inflexible.
Back to top
NickDenny
Fri Jul 24 2015, 06:52PM
NERO LARP Staff

Registered Member #122
Joined: Mon Aug 08 2011, 10:56AM
Posts: 81
1 inch thin walled (pressure pipe) PVC is what I always use for 2 handed weapons on the cheap. Very light and ridged. Note this is thinner walled than Sch 40 PVC pipe which is also white. Call around as not all hardware stores carry it, but I am pretty certain Lowes and maybe Menards do. I do not think that Home Depot does.
Back to top
PapaGrelada
Tue Aug 04 2015, 03:14PM
Registered Member #58781
Joined: Wed May 13 2015, 06:52PM
Posts: 2
thank you, Furthermore that schd 40 PVC sounds much cheaper
Back to top
 

Jump:     Back to top

Syndicate this thread: rss 0.92 Syndicate this thread: rss 2.0 Syndicate this thread: RDF
Powered by e107 Forum System